TOP-FIX

A TOP DOWN APPROACH

Fitting a waste can be one of the slightly
awkward jobs, with plumbers often needing to simultaneously coordinate what is going on
both above and below the sink or shower in
order to fit the waste.

Designed to make the task easier,
TOP-FIX is a solution that means the waste
can be fitted from  above.

DROP IN FROM ABOVE

A two-piece solution, which is ‘dropped-in’ through the waste hole from above, means no parts need to be held in place from below the sink or shower. Once in  place, the two main pieces of TOP-FIX are then tightened with a bolt, pulling them together and creating a seal.  

The 14mm bolt which runs through the centre
of the  unit can be tightened using either a ‘key’ (which is supplied in the box) or with a drill with a 14mm socket set. If the installer is using a drill, the use of a low setting is recommended to make sure the threads of the bolt are protected.

PULL TOGETHER

The action of tightening the bolt draws the two parts of TOP-FIX together, with the bottom pulled back against the underside of the sink or shower. This creates a seal which is 100% watertight. There’s no need for any sealant – which can help make the job less messy and allow plumbers to keep the work area clean and tidy.

​

The solution has been engineered to work
with all UK plumbing systems, both older
and modern showers and sinks.